Sub-Zero Appliance Repair Los Angeles
(310) 496-7399

8:00 am – 8:00 pm, seven days

Book a visit
Menu

Westside and canyons · 90049

Sub-Zero Service in Brentwood

South of Sunset the kitchens are full of built-ins fitted in the nineties and early two-thousands, and almost all of them are still worth repairing. They were designed to be serviced in place, and the parts for them have not gone away.

Opens first on
Refrigerator column
Working hours
8:00 am – 8:00 pm, seven days
Phone
Picked up 24/7
Meter probes held on a white wiring connector in the open lower bay of a stainless cabinet, compressor and condenser fan shroud behind
In the frame
  1. Wiring connector
  2. Compressor
  3. Condenser fan
Local condition What ages faster because of it If it is the part
Level streets, garage access A column can usually be rolled out rather than walked out, which keeps a cabinetry job from turning into a carpentry one
Thirty years of dry inland air Condenser coils load slowly but steadily; nothing dramatic, and nothing that clears itself either $300–$720
Original nineties wiring in the bay Connectors and relays go brittle long before the compressor does, and read on a meter as a dead cabinet $440–$980
Two-circuit cabinets, one panel One side can fail entirely while the other holds, which rules out the expensive answers before anything is opened $280–$610

Level access, ageing wiring, two separate circuits. Sub-Zero Appliance Repair Los Angeles works this stock every week and quotes from the table before a panel moves — (310) 496-7399, $89 to come out.

Ranges cover parts and labour on this company's own price bands; the $89 service call is separate until you approve the work, and then it is not.

What this stock is actually like

A built-in from 1997 is not a tired appliance. It is a machine with a serviceable sealed system, a two-circuit design and a parts supply that still exists, sitting in a kitchen that was built around it. Replacing one means replacing the joinery too, and that is the number that changes the argument.

What does wear out on this vintage is everything with a contact in it: connectors in the lower bay, relays, the odd thermistor. They fail quietly and they present badly — no lights, no response, nothing on the panel — which is exactly the shape people read as the end of a compressor.

How a visit here runs

Flat streets and garage access mean a column normally rolls out on its own feet, so the first half hour goes on readings rather than on moving furniture. Shelf temperatures against the panel, the condenser looked at whatever the call was about, and a meter on the connectors before anything is quoted.

If the cabinet turns out to be beyond sensible repair, that gets said. It rarely is, on this stock, and saying so when it is not would be the easiest untruth on the whole route.

Reviews

Read afterwards, not during

4.9/ 5666 reviews

  • Both zones had settled on one temperature whatever we set them to. A stuck damper and a dead zone sensor. He replaced both, then let it run and checked each shelf with a probe before leaving.

    Esme T.Brentwood

  • Our 1990s built-in came with the house and nobody else wanted to touch it. He found a failed defrost thermostat and a filthy condenser, sorted both, left the readings on paper. Booking took two tries.

    Adela V.Brentwood

  • The fridge side climbed into the high fifties through a hot week while the freezer column stayed at zero. Evaporator fan on that circuit had seized. Replaced on the spot, and it has held since.

    Bennett R.Brentwood

Booking

Ring while it is still misbehaving

A fault described as it happens is worth more than a fault remembered: the shelf reading, the noise, the number on the panel. Catch it live and the visit begins somewhere in the middle rather than at the start.

A bagged filter-drier, a bagged wiring harness, three nut drivers and a multimeter laid out on a towel in front of an open machine bay
To come out
$89, credited back on an approved repair
Technicians working
8:00 am – 8:00 pm, seven days
Who picks up
A person, 24/7